FABRICATED
MICA PRODUCTS
CRIMPED/CORRUGATED
MICA
Corrugated
Mica made from Muscovite & Phlosovite mica. It is used in
manufacturing of Soldering Iron Heating Insulations. Corrugated
Mica is supplied as per buyers specification. It stands at a high
temperature of upto 1000oC.
|
|
ROLLED
MICA TUBE
This
tube is made from Mica Splitting for use in standing temperature
of upto 600oC in a very small size.
|
|
MICA
HEATING ELEMENT
Mica
Heating Elements are made of superior quality MICA having excellent
dielectric strength, capable to withstand high voltage spikes,
resists moisture, provides thermal stability and quick heat transfer
to the sheath. They are precisely wounded with high temperature
resistance ribbon wire which provides even heat distribution,
guarantee maximum service life and complete safety without any
break-down under ordinary working conditions. They are not affected
by the severity of heating and cooling cycle.
|
|
MICA
SPACERS FOR ELECTRONIC TUBES
Natural
Sheet Mica is used in the thermionic vacuum tubes, in radio and
television sets, in the form of bridges and spacers. These mica
components serve to hold the tube elements in position, equidistant
and insulated from each other. Practically, every tube in the
receiving sets contains two or four pieces of mica - two pieces
known as bottom or upper supports or bridges, and the other two
pieces as clips or spacers. The clips or spacers fit over the
upper support in some cases over the grids and keep the whole
assembly centered in the tube by contact with the sides.
|
|
MICA
STRAINER CORES
MICA
STRAINER CORES are suitably used by metal casting foundaries for
brass, bronze and aluminium sand castings, as well as for some
smaller ferrous castings to pour their melts through mica strainer
cores to catch impurities and control the pour rate.
|
|
MICA
FOR SOLDERING IRON
A
thin rectangular mica film, wrapped around the entire length of
the flat part of the copper it of a soldering iron, plays a vital
role by helping not only to eliminate physical contact between
the resistance wire and the copper bit to avoid short circuit,
but also ensures low resistance to heat transfer and high efficiency
in the operation of the instrument. Mica ensures a long, efficient
and dependable service life and rugged operation to a soldering
iron. A mica insulated soldering iron could be operated for longer
hours without any fear of being burnt, a problem that usually
lurks in the mind of an electronic engineer. Mica, with its great
range of properties, means cost efficiency and product realiability
in the long run.
|
|
MICA
INSULATORS/HEAT SINK MICA/ SURFACE MOUNTING WASHERS
Transistors
and other Semiconductors including solid state electronic systems
are finding increasing applications as washers and supports made
of medium quality natural sheet mica for both electrical and heat
insulation due to their excellent mechanical and thermal properties.
Power Transistors and diodes need some type of insulation to prevent
excessive heat from reducing their performance. Precision punched
natural Mica Washers help the transistor to be insulated from
the chasis, at the same time it plays a dual function to dissipate
the heat way from the Transistor and other Semiconductors thereby
keeping them cool. Its added advantages are low moisture absorption,
high breeakdown voltage and high resistance to surface leakage.
The high heat resistance and mechanical strength of mica make
them ideal for use in Computers, Radios, Car-ignitions and most
common types of semi-conductors and circular components.
|
|
MICA
MANUFACTURING CO. PVT.LTD.
3C,
Camac Street, P.O.Box
9052,
Kolkata 700 016 INDIA
Tel: +91-33-40663006
E-mail
:mica@micamaf.co.in / mmc@micamafco.co.in
|